Use:
If the nozzle is clogged, use the drill so that you will gently and slowly in the clockwise. Do not try to push the drill straight into the nozzle, it could break it!
Warning:
When cleaning the nozzle, be sure to preheat it at min 200 ° C.
Note:
The color on the handle may actually differ from the color given on the sprays. However, this does not affect the quality or use of the product.
9,74 €
Brass brush for cleaning and removing peeling dirt from print strings from nozzles, hotends, heated cubes, pads, etc.
In stock 10 to 100 pcs (74 pcs)
3,36 €
Round brush with brass fibers with a 3 mm shaft for clamping in a dremmel or drill. With the brush, you can easily remove dirt from your nozzle and other parts of your 3D printer.
In stock 10 to 100 pcs (85 pcs)
1,23 €
Needle to clean nozzles 0.2 mm and larger.
In stock 10 to 100 pcs
0,64 €
Drill bits with a diameter of 0.2 mm / 0.25 mm / 0.3 mm / 0.35 mm / 0.4 mm / 0.45 mm / 0.5 mm used for cleaning nozzles. If the nozzle is clogged, heat it to approx. 200 °C and then clean it with a drill in gentle circular movements in a clockwise direction.
In stock <10pcs
0,81 €
We use cookies to improve your visit to this website, to analyze its performance and to collect data about its use. We may use third party tools and services to do so and the data collected may be passed on to partners in the EU, the US or other countries. By clicking on "Accept all cookies", you agree to this processing. You can find detailed information or adjust your preferences below.
