na3D
Producer website: www.na3D.cz
-
Set 4 x Driver TMC2130 SPI Cable
Set four pieces of TMC 2130 stepper drivers with SPI bus output, including connection cable.
Sold out
46,76 €
-
Ball bearing 626ZZ
Single -row ball bearing 6W6 2Z suitable for high and extremely high temperatures. Size 6x19x6 mm. 626 ZZ (the product can be ordered for 1 piece, photographs are only illustrative.)
Sold out
0,81 €
-
Ball bearing 628ZZ
Ball bearing 628ZZ, 8x24x8 mm. (The product can be ordered after 1 piece, the photo is only illustrative.)
Sold out
1,23 €
-
LM16ULU linear bearing
Extended linear bearing suitable for assembly into a wide range of printers. Suitable for guide bars with a diameter of 16 mm. (The product can be ordered after 1 pc.)
Sold out
8,47 €
-
LM25UU linear bearing
Extended linear bearing suitable for assembly into a wide range of printers. Suitable for guide rods with a diameter of 25 mm. (The product can be ordered after 1 pc.)
Sold out
11,87 €
-
3DLAC plus
A non -pressure variant of the popular 3DLAC spray. Volume 100 ml. The sprayer is sufficient for more than 200 spraying of the pad (the advantage is that it is not necessary to re -apply before each print with a properly applied first layer). In case of dissatisfaction we offer a refund within 30 days.
Sold out
8,89 €
-
GT2 pulley - black anodized
Pulley for mounting on a motor or rod with the possibility of securing with two screws (worms). Black GT2 pulley with 20 teeth for 5mm motor shaft (inner pulley hole 5mm). (The product can be ordered 1 piece at a time, the photo is only illustrative.)
Sold out
2,51 €
-
Induction proximity sensor LJ18A3-8-Z/BX
Sensor 8 mm detection distance. The sensor indicates the detection of the object by the appearance of the low state at the output and activation of the red LED. The sensor is equipped with a cable with a length of about 1m and a nut for easy assembly. The sensor is equipped with a cable with a length of about 1 m and a nut for easy assembly. The sensor tightness class is IP67. The power range...
Sold out
10,59 €
-
Set of travel rods Rebelix x2
Set of hardened travel rods for assembling 3D Rebelix X2 printers.
Sold out
21,23 €
-
Power Panic v0.4
Connector before the source for monitoring a decrease in network connection. Supports 12 and 24 V.
Sold out
21,23 €
-
Prusa MMU Control V2
Control board for multimatcher printing. Prusa mm Control
Sold out
42,51 €
-
CR10 heatblock cube
Replacement aluminum cube (Heatblock) for extruders on Creality printers.
Sold out
3,36 €
-
U604ZZ - bearing with groove for filament pressure
Bearing with groove for filament pressure. Most often used in the MK8 extruder. (The product can be ordered after 1 piece, the photo is only illustrative.)
Sold out
1,23 €
-
Magnetic print pad with magnetic sticker 220 x 220 mm
Magnetic printing pad with dimensions of 220 x 220 mm for better adhesion of prints. It is a two-part set, where a detachable magnetic pad guarantees easier removal of the printed products.
Sold out
10,59 €
-
Motor connector - dual z
Motor connector - suitable for dual Z. Parallel connection of 2 engines to one output of the control board.
Sold out
2,08 €